Cold Mold 2 part Compound Kit

Now you can make a rubber mold for casting pewter or other low melt alloys without heat and without mixing and pouring liquids. This 0% shrinkage silicone rubber is a 2-part putty that you simply knead together and then press into a standard mold frame to cure under pressure, without heat for 30 minutes. Packaged in two containers, part A and part B, weighing a total of 1.3 lbs.

• Working Time:  2 min. (approx)
• Cure Time:  30 min. (approx)
• Durometer:  35
• Shrinkage:  0%
• Tensile Strength:  400 psi
• Tear Strength:  55 ppi
• Elongation:  375%

 KIT CONTAINS:                                                                                                                                       

1- Packaged in two containers, part A and part B Cold Mix 

20 - Acorn Nuts which you will install between the two halves of an unvulcanized rubber mold to insure the proper orientation of the two halves. Because of their six-sided configuration, Acorn Nuts have a holding ability superior to any other form of mold locator.

 1- Blade handle shown is used with mold cutting blades.

 10 - Mold Cutting Blades very popular with mold makers for their sharpness

 1- Tweezers in the style of the Swiss Boley AA tweezers.  Anti-magnetic stainless steel with very fine points. 5" length.

DIRECTIONS